Modeltech P-51D Mustang Electric Conversion

Recently, someone the I consider to be a good friend, donated this plane to my obsession - electric-powered flight! Mark Lukens (www.thelukens.net) made the offer and I jumped all over it!

What it boiled down to is a nicely powered (albeit, lighter) plane. It's not set up for unlimited verticals, etc. - but she does fly scale very nicely.

So, what were the obvious changes? Here is the list:

1. 60A Suppo ESC (max 80A <>
2. 1000kv Suppo outrunner (A2826/4T) - axi clone ($36)
   
3. Spektrum AR500 (5 channel full-range rx) ($54)
   
4. 5A switching BEC ($9)
   
5. 4S1P A123
   
6. 5S1P A123 (a little more rpm than with 4S1P due the additional cell)
7. 12 & 14 gauge silicone power leads
8. APC12x10E prop
9. Weight reduction to 5.6lbs
   

In case anyone is wondering, the BEC, ESC and motor (totaling approx $71) came from rchotdeals.com. They carry the same ESCs and motors that lightflightrc carries, but at a lower price, they have a lot of items in stock and they email you your order details - which lightflightrc doesn't do so it's sometimes hard to go back and review what I ordered from them.

The A123 battery packs are custom built packs that I made about 1 year ago. They're still holding a lot of charge and delivering massive amounts of current.

Next weekend I'll make some very detailed flights to determine if I need to go with 2P (doubling the 4S and 5S packs - which doubles flight time, but also the battery weight). I haven't done any power consumption testing over time. I can tell you this - the current setup runs between 54A-56A WOT (wide-open-throttle). Obviously we don't always fly that way, but it's nice to know that you won't over-draw the motor, ESC or battery capabilities.

Below are some obligatory pics :)

Prior to installation (courtest of USPS and rchotdeals.com)

ESC and motor installed - lot's of cooling for both

Back together and looking sweet...


My original collet adapter and spinner were offset so the maiden flight had some noisy vibration. This is the result - no spinner :(

The conversion only took a about two hours. The most effort was in calculating the power consumption and prop size+pitch to the weight of the aircraft and the capacity of the batteries and ESC.

All-in-all, a very nice aircraft!

Thanks everyone for stopping by and a BIG thanks to Mark for making this happen and taking her up on her maiden (electric-powered) flight.